The last time I checked, this opcode worked without problems, and it was
not changed since then, if I recall correctly. Could you post an example
where it does not appear to behave the intended way ?

On Thursday 04 May 2006 00:35, luis jure wrote:

> either i don't understand the pareq opcode correctly, or it's not behaving
> as advertised.
> 
> from the manual:
> 
> kv -- amount of boost or cut. A value less than 1 is a cut. A value greater 
> than 1 is a boost. A value of 1 is a flat response.
> 
> but values from 0 to 1 leave the signal unchanged. i can only get boost, no
> cut.
> 
> could anyone confirm this? thank you.