kgain=1 not 0 for a flat response.
----- Original Message -----
From: "Jonatan Liljedahl" <lijon@kymatica.com>
To: "Developer discussions" <csound-devel@lists.sourceforge.net>
Sent: Wednesday, May 21, 2008 10:14 PM
Subject: [Cs-dev] eqfil manual confusion
> "The amplitude response for this filter will be flat (=1) for kgain=0.
> With kgain is bigger than 1, there will be a peak at the centre
> frequency, whose width is given by the kbw parameter, but outside this
> band, the response will tend towards 1. Conversely, if kgain is smaller
> than 1, a notch will be created around the CF."
>
> Is it flat with kgain==0 or 1? The first part says it's at 0, but at the
> end it says that smaller than 1 creates a notch.
>
> --
> /Jonatan [ http://kymatica.com ]
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Csound-devel mailing list
> Csound-devel@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/csound-devel
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Csound-devel mailing list
Csound-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/csound-devel