Fixed in cvs. Thanks. On Wed, May 21, 2008 at 4:47 PM, victor wrote: > kgain=1 not 0 for a flat response. > ----- Original Message ----- > From: "Jonatan Liljedahl" > To: "Developer discussions" > Sent: Wednesday, May 21, 2008 10:14 PM > Subject: [Cs-dev] eqfil manual confusion > > > > "The amplitude response for this filter will be flat (=1) for kgain=0. > > With kgain is bigger than 1, there will be a peak at the centre > > frequency, whose width is given by the kbw parameter, but outside this > > band, the response will tend towards 1. Conversely, if kgain is smaller > > than 1, a notch will be created around the CF." > > > > Is it flat with kgain==0 or 1? The first part says it's at 0, but at the > > end it says that smaller than 1 creates a notch. > > > > -- > > /Jonatan [ http://kymatica.com ] > > > > ------------------------------------------------------------------------- > > This SF.net email is sponsored by: Microsoft > > Defy all challenges. Microsoft(R) Visual Studio 2008. > > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > > _______________________________________________ > > Csound-devel mailing list > > Csound-devel@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/csound-devel > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Csound-devel mailing list > Csound-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/csound-devel >